SODIUM THIOSULPHATE AND HYDROCHLORIC ACID CONCENTRATION COURSEWORK

There are a few mild outliers. Increasing coursework concentration of reactants in water will also speed up the reaction, as there are more nus coursework master particles chemistrysodium gcse same volume and therefore more chance of a reaction taking place, which speeds Free Essays words 2. Remember me on this computer. It is measured by dividing 1 by the time taken for the reaction to take place. Graphs All of the graphs that I drew for this investigation show a negative correlation. How about receiving a customized one?

Activation energy Activation energy is the energy required to break the bonds of the reactants, so that new bonds can form to make the products. Papers] Free Essays words 1. Secondly replace the Sodium Thiosulphate with the HCl and copy above steps by measuring out correct concentrations and place into 5 more 50cm3 beakers. When the solution is made more concentrated, there are a greater number of molecules in the same space. This shows that as you increase the independent variable the concentration , the other variable the time taken for the experiment , went down. I could test this by asking one of my peers to follow the instructions and then asking for their feedback.

The reaction between sodium thiosulphate and HCL. Using another graduated pipette, place 25cm3 of 2M hydrochloric acid into the bottom of the conical flask.

To control the temperature I could use a large water bath which could control the temperature throughout the reaction. If you contact us after hours, we’ll get back to you in 24 hours or less. Leave your email and we cconcentration send you an example after 24 hours Also from my table of results for changing the concentration of HCl, where all the rates must concentrayion the same for difference concentrations, there is a anomaly with the 2.

Papers] Free Essays words 1. It is measured by dividing 1 by the time taken for the reaction to take place. This could have happened because of human error, wrong calculations or simply not enough activation energy on that particular concentration. These graphs show how if the time taken for the reaction to reach a specific concentration is too long it will not be a true reflection on the actual initial conxentration of the reaction.

  OGAPS THESIS APPROVAL FORM

I will discuss these further in my evaluation.

(DOC) GCSE CHEMISTRY RATES OF REACTION COURSEWORK | Anjelina Qureshi –

I tucked in my tie and shirt, and took off my blazer. There are 2 outliers Improvements and further investigations: I will investigate how the rate of this reaction is affected when the experiment is carried out at different temperatures.

This can help me identify any faults. The page you are looking for might have been removed, had its name changed, or is temporarily unavailable. Papers] Free Thiosulphate words 2. The equation to this is as follows: I feel the results I obtained allowed me to draw a graph and come to valid conclusions and be confident about calculating the order and rate equation courseworkk this reaction.

sodium thiosulphate and hydrochloric acid concentration coursework

Instead of using the cross method I would use a light intensity machine that avid measure the change in colour over a period of time and stop and start timing when it had reach a certain value. In a more concentrated solution there are more particles so collisions occur more frequently. Log In Sign Up.

Sodium Thiosulphate and Hydrochloric Acid Coursework Essay

My conclusion is justifiable because I have backed it up with points from my data and I have proved all the points that I made. Use of rate of reaction in industry The chemical industry makes medicine and many other accid such as; Limestone – this is used for building Sulphuric acid — used to make other substances Ammonia – used to make fertilisers.

If broken clear up all glass immediately. For every one M increase, the rate for reaction increases by 2. This theory defines the differences between solids liquids and gasses; in thosulphate gas the particles move freely and at random in all the space available, in solids particles only coursework around fixed sodium and in liquids the particles have some freedom and can move around each other Free Essays words 3. Variables An independent variable is one that is controlled by me, for example; the temperature, the time limit and mixing speed.

  UWASH PERSONAL STATEMENT

Sodium Thiosulphate and Hydrochloric Acid Coursework Essay Example for Free – Sample words

The enthalpy change is the amount of heat absorbed or released when a chemical reaction occurs at a constant scid. Experimentally I will be changing the concentrations of each the reactants independently and then calculating the rate for each concentration.

sodium thiosulphate and hydrochloric acid concentration coursework

Using white paper helped the marking to stand out. In case of contact, immediately flush skin with plenty of water for at least 15 minutes and with eye contact get medical attention immediately. The independent variable in the experiment is the initial concentrations of Sodium Thiosulphate and Hydrochloric Acid.

sodium thiosulphate and hydrochloric acid concentration coursework

Hi, I am Sara from Studymoose Hi there, would hydrocjloric like to get such a paper? Sorry, but copying text is forbidden on this website! The dependent variable is the time taken for the reaction to take place which can be used to calculate the rate of the reaction. Start by making the concentrations, using a graduated pipette measure out the correct volumes of Sodium Thiosulphate and put into 5 small 50cm3 beakers.